EZCast PRO with a 4:3 ratio resolution

[Heiko]

Hello EZCast,

we just upgraded 11 smartboards with an ezcast pro dongle at our school.

Now we have a limitation with the beamer resolution. The screen of the smartboard has a 4:3 ratio and
a recommended resolution with 1024 x 768 by 60p.

All the possible dongle resolutions have a ratio with about 17:10. So the beamer does not fill out
the full screen. The beamer can stretch the picture, but than we have a distorted picture.
The teachers complaining about this situation, because the students would see, for example, incorrect
country borders or math graphs.

Could you add a resolution with a 4:3 ratio like 1024x768 or 1280x1024 with 60p in the firmware please?


Best regards from Germany

Heiko

[Henry Chou]

Dear Heiko:

May I know your dongle is EZCast or EZCast Pro dongle?
Thanks for your information and help.

BR,
EZCast: Henry

[Heiko]

Hi,

it´s EZCast Pro.


Thank you

Heiko

[Henry Chou]

Dear Heiko:

For EZCast Pro series, 4:3 resolution is only for the products with VGA output, like EZCast Pro LAN.
Please refer to http://www.iezvu.com/ezcast_pro.php?l=en
Thanks for your understanding.

BR,
EZCast: Henry